revertive:
The definition of revertive mode means that if the failure has been recovered, the original failured working path will be cutover the current working path which are assigned to be the protection path based on the operator or system.
Non-revertive:
it means that the current working path,which has replaced the original working path when the protection condition is meeted, would not be revertive even the failure has been solved.
Two modes can be freely chosen by the operator. Let me compare with you about the difference between two modes.
Non-revertive mode is no need to switch again, it means that it has no possibility to produce any hit. Because the system would not take any action on it.
Revertive means that there will be a circuit revert. Even the technology can be promised that the procedure is hitless, however it may be risky because some uncertain conditions.
However, Non-revertive mode may occupied the higher cost resource to carry the traffic, or the operator think the protection circuit is not suitable for some other administrative reasons to carry the traffic after recovery. Therefore the system should take revertive action.
Actually such function is always been ignored by the operator. Because it indeed belong to minor questions.
With the data traffic devlopment in the meshed network. This function will be more considered by operator based on the network performance and network optimization.
时间: 2004-7-13 15:25
作者: wxnire
多谢楼上TX,十分详尽!
时间: 2004-7-13 22:18
作者: U.U
说白了。1+1一般non-revertive,1:N的就revertive
时间: 2015-12-21 14:40
作者: Mr_Lan
学习了学习了
时间: 2021-12-11 11:22
作者: Rcong
算命先生 发表于 2004-7-12 17:56
revertive:
The definition of revertive mode means that if the failure has been recovered, the orig ...