以下是汇聚侧路由器其中一条子接口的配置信息：
interface Serial7/1/9/26:0
description Connect To to MeiLing
link-protocol hdlc
ip address 10.224.211.105 255.255.255.252
ospf authentication-mode md5 99 cipher 5W97B'/VOV+Q=^Q`MAF4<1!!
qos apply policy area1_p1 inbound
#
<YZ_SR8808_01>dis interface Serial7/1/9/26:0
Serial7/1/9/26:0 current state: UP
Line protocol current state: UP
Description: Connect To to MeiLing
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Derived from Cpos7/1/9 e1 26, Unframed mode, Baudrate is 2048000 bps
Internet Address is 10.224.211.105/30 Primary
Link layer protocol is HDLC
CRC type is 16-bit
Last 300 seconds input: 740 bytes/sec, 6 packets/sec
Last 300 seconds output: 115 bytes/sec, 1 packets/sec
Input(total): 292419 packets, 26398148 bytes
Input(Bad): 1247 Abort, 213 FCS-Error, 0 FIFO-Abort, 0 Giant, 0 Runt
Output(total): 314377 packets, 64165187 bytes
Output(Bad): 0 Abort
Input packet peak value: 1133 bytes/sec, at 08:10:57 17-12-2008
Output packet peak value: 25570 bytes/sec, at 08:10:57 17-12-2008
以下是对应终端路由器配置信息：
sh run
Building configuration...
Current configuration : 4034 bytes
!
version RGNOS 10.3.00(4), Release(36819)(Thu Apr 10 15:42:03 CST 2008 -ngcf31)
hostname yzwy_1562
!
!
!
!
!
!
route-map pbr permit 10
match ip address 1
set ip next-hop 10.224.208.105 10.224.211.105
!
route-map pbr permit 20
match ip address 2
set ip next-hop 10.224.211.105 10.224.208.105
!
!
!
no service password-encryption
--More--
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
ip access-list standard 1
10 permit 10.41.139.0 0.0.0.63
!
!
ip access-list standard 2
10 permit 10.42.151.192 0.0.0.31
20 permit 88.97.24.96 0.0.0.15
--More-- !
!
ip access-list standard 50
10 permit 10.41.0.0 0.0.255.255
!
!
ip access-list extended 101
10 deny ip 10.41.0.0 0.0.255.255 10.42.0.0 0.0.255.255
20 deny ip 10.42.0.0 0.0.255.255 10.41.0.0 0.0.255.255
30 deny ip 10.41.0.0 0.0.255.255 88.97.0.0 0.0.255.255
40 deny ip 10.42.0.0 0.0.255.255 88.97.0.0 0.0.255.255
50 deny ip 88.97.0.0 0.0.255.255 10.41.0.0 0.0.255.255
60 deny ip 88.97.0.0 0.0.255.255 10.42.0.0 0.0.255.255
200 permit ip any any
!
!
!
control-plane
!
control-plane protocol
!
control-plane manage
!
control-plane data
--More-- !
!
logging buffered 131072
enable secret 5 $1$jsMo$pBrz27zv23z9DAvv
enable password yzwy_1562
!
!
!
!
class-map match-all yingye
match access-group 50
!
!
policy-map qos
class yingye
bandwidth percent 30
queue-limit 256
!
interface Serial 3/0
encapsulation frame-relay ietf
no frame-relay inverse-arp
frame-relay map ip 10.224.208.105 80 broadcast
frame-relay lmi-type ansi
ip ospf network point-to-point
--More-- ip ospf message-digest-key 99 md5 cisco
ip ospf mtu-ignore
ip address 10.224.208.106 255.255.255.252
service-policy output qos
bandwidth 2048
!
interface Serial 4/0
ip ospf network point-to-point
ip ospf message-digest-key 99 md5 cisco
ip ospf mtu-ignore
ip address 10.224.211.106 255.255.255.252
service-policy output qos
bandwidth 2048
!
interface FastEthernet 0/0
duplex auto
speed auto
!
interface FastEthernet 0/2
duplex auto
speed auto
!
interface FastEthernet 5/0
duplex auto
--More-- speed auto
!
interface FastEthernet 5/0.1
encapsulation dot1Q 100
ip policy route-map pbr
ip access-group 101 in
ip address 10.41.139.1 255.255.255.192
!
interface FastEthernet 5/0.2
encapsulation dot1Q 200
ip policy route-map pbr
ip access-group 101 in
ip address 10.42.151.193 255.255.255.224
!
interface FastEthernet 5/0.3
encapsulation dot1Q 300
ip policy route-map pbr
ip access-group 101 in
ip address 88.97.24.97 255.255.255.240
!
!
!
!
!
--More-- !
router ospf 100
passive-interface default
no passive-interface Serial 3/0
no passive-interface Serial 4/0
area 1 authentication message-digest
network 10.41.139.0 0.0.0.63 area 1
network 10.42.151.192 0.0.0.31 area 1
network 10.224.208.104 0.0.0.3 area 1
network 10.224.211.104 0.0.0.3 area 1
network 88.97.24.96 0.0.0.15 area 1
!
!
!
!
!
!
!
snmp-server community public ro
snmp-server community private rw
!
ref parameter 85 400
line con 0
line aux 0
--More-- line tty 1
telnet address 10.41.112.61 8110 /source-interface FastEthernet 5/0.1
disconnect-character 4
autocommand start-terminal-service
speed 115200
flowcontrol software
line tty 2
telnet address 10.41.112.61 8111 /source-interface FastEthernet 5/0.1
disconnect-character 4
autocommand start-terminal-service
speed 115200
flowcontrol software
line tty 3
telnet address 10.41.112.61 8112 /source-interface FastEthernet 5/0.1
disconnect-character 4
autocommand start-terminal-service
speed 115200
flowcontrol software
line tty 4
telnet address 10.41.112.61 8113 /source-interface FastEthernet 5/0.1
disconnect-character 4
autocommand start-terminal-service
speed 115200
flowcontrol software
--More-- line tty 5 8
disconnect-character 4
flowcontrol software
line vty 0
login
password yznh
line vty 1 4
login
password yznh
flowcontrol software
line vty 5 8
login
flowcontrol software
!
!