| PCCPCH RSCP[size=9.0000pt] | Primary Common Control Physical Channel Received Signal Code Power[size=9.0000pt] | -115~-25[size=9.0000pt] | dBm[size=9.0000pt] | 主公共控制物理信道的平均接收信号码功率[size=9.0000pt] |
| DPCH RSCP[size=9.0000pt] | Dedicated Physical Channel Received Signal Code Power[size=9.0000pt] | -120~-57[size=9.0000pt] | dBm[size=9.0000pt] | 专用物理信道的平均接收信号码功率[size=9.0000pt] |
| Path Loss[size=9.0000pt] | Path Loss[size=9.0000pt] | 30~165[size=9.0000pt] | dB[size=9.0000pt] | 主公共导频信道的路径损耗[size=9.0000pt] |
| UTRA Carrier RSSI[size=9.0000pt] | UTRA Carrier RSSI[size=9.0000pt] | -94~-32[size=9.0000pt] | dBm[size=9.0000pt] | 载波RSSI[size=9.0000pt] |
| Timing Advance[size=9.0000pt] | Timing Advance[size=9.0000pt] | -1024~1024[size=9.0000pt] | chip/8[size=9.0000pt] | 时间提前量，用于计算手机和基站之间的距离，意义同GSM_TA TA 主要用来控制手机发送的时间（TDMA)来保证bts在正确的接收窗口内接收而不会和其它手机的发送burst重叠导致接收decode失败。TA是由网络根据ms发送的rach计算得来的，rach burst很短，来避免多个rach重叠的机会，而且ta = 0. [size=9.0000pt] |
| Timing Advance[size=9.0000pt] | Timing Advance[size=9.0000pt] | -1024~1024[size=9.0000pt] | chip/8[size=9.0000pt] | 时间提前量，用于计算手机和基站之间的距离，意义同GSM_TA TA 主要用来控制手机发送的时间（TDMA)来保证bts在正确的接收窗口内接收而不会和其它手机的发送burst重叠导致接收decode失败。TA是由网络根据ms发送的rach计算得来的，rach burst很短，来避免多个rach重叠的机会，而且ta = 0. [size=9.0000pt] |
| UpPCH TxPower[size=9.0000pt] | Uplink Pilot Channel Transmit Power[size=9.0000pt] | -50~24[size=9.0000pt] | dBm[size=9.0000pt] | 定义为UE在一个载波上上行导频信道的平均发射功率[size=9.0000pt] |
| BLER[size=9.0000pt] | Block Error Ratio[size=9.0000pt] | 0~100[size=9.0000pt] | [size=9.0000pt]%[size=9.0000pt] | 误块率[size=9.0000pt] |
| UE_TxPower[size=9.0000pt] | User Equipment Transmit Power[size=9.0000pt] | -50~34[size=9.0000pt] | dBm[size=9.0000pt] | 定义为UE在一个载波一个时隙上的平均发射功率[size=9.0000pt] |
| PCCPCH SIR(dB)[size=9.0000pt] | Primary Common Control Physical Channel [size=9.0000pt] | -11~20[size=9.0000pt] | dB[size=9.0000pt] | 主公共导频信道的SIR[size=9.0000pt] |
| C/I(dB)[size=9.0000pt] | carrier-to-interference ratio[size=9.0000pt] | -20~25[size=9.0000pt] | dB[size=9.0000pt] | 载干比。加到接收天线输入口的有用载频功率（[size=9.0000pt]C）与干扰信号（[size=9.0000pt]I）功率的比值。[size=9.0000pt] |
| UARFCN[size=9.0000pt] | UTRA Absolute Radio Frequency Channel Number[size=9.0000pt] | 0~32678[size=9.0000pt] | [size=9.0000pt] | 主服务小区的主频点[size=9.0000pt] |
| DRX Coefficient[size=9.0000pt] | Discontinuous Reception Coefficient[size=9.0000pt] | 3~9[size=9.0000pt] | [size=9.0000pt] | DRX循环长度系数，用于计算指定UE的寻呼次数[size=9.0000pt] |
| TrCH Count[size=9.0000pt] | Transmit Channel[size=9.0000pt] | 0~32[size=9.0000pt] | [size=9.0000pt] | 传输信道的总个数[size=9.0000pt] |
| CS Service[size=9.0000pt] | Circuit Switched Service[size=9.0000pt] | [size=9.0000pt] | kbps[size=9.0000pt] | 电路交换业务的编码速率[size=9.0000pt] |
| PS Service[size=9.0000pt] | Packet Switched Service[size=9.0000pt] | 64,128,384[size=9.0000pt] | kbps[size=9.0000pt] | 分组交换的传输速率，现在只支持[size=9.0000pt]3种速率[size=9.0000pt] |
| SS[size=9.0000pt] | [size=9.0000pt] | [size=9.0000pt]0[size=9.0000pt]～[size=9.0000pt]3[size=9.0000pt] | [size=9.0000pt] | 帧同步偏移，目前只在下行时隙中发送，上行时隙没有SS信息，但是保留了SS位置。[size=9.0000pt] |
| 通信人家园 (https://www.txrjy.com/) | Powered by C114 |