通信人家园

标题: ZTE C300 EPON业务配置疑问 [查看完整版帖子] [打印本页]

时间: 2016-1-31 09:28

作者: jidahyx 标题: ZTE C300 EPON业务配置疑问

C300 EPON业务配置的时候，
可以使用这两种方式配置：
service-port 1 user-vlan 4092 vlan 4092
或
switchport vlan 4092 tag 的

两个命令究竟有何差异？

时间: 2016-1-31 09:51

作者: jidahyx

没有熟悉C300的弟兄吗？

时间: 2016-1-31 09:53

作者: jidahyx

MAC地址学习正常：
c300(config)#show mac
Total mac address : 3

Mac address    Vlan id Type    Port                      Vc    Time
----------------------------------------------------------------------------
741f.4a46.ec50 101    Dynamic gei_1/19/1                         10
0000.0000.0007 4092 Dynamic gei_1/19/4                         10
0000.0000.0006 4092 Dynamic epon-onu_1/17/8:1       vport 1 0
c300(config)#
上行数据已经上来了， 1000pps
c300(config)#show interface epon-olt_1/17/8
epon-olt_1/17/8 is activate,line protocol is up.
  Description is none.
  The port is activate.
  The port link up/down notification is trap disable.
  The port has 64 onus,  the number of registered onus is 1
OLT statistic:
Input rate :          990760 bps             998 pps
Output rate:                0 bps             0 pps
Input bandwidth thoughput :0.1%
Output bandwidth thoughput:0.0%
Interface peak rate:
Input peak rate :          10214120 bps          1541 pps
Output peak rate:                0 bps             0 pps
Total statistic:
  Input:
PassPackets :2433623             PassBytes    :618040896
UnicastsPkts  :2432943             MulticastsPkts:177
BroadcastsPkts:503
CRCAlignErrors:0                   OversizePkts  :0
UndersizePkts :0                   CollisionPkts :0
Fragments    :0                   Jabbers    :0
64B    :11                      65-127B :1926969
128-255B  :46690                   256-511B  :93114
512-1023B :185671                1024-1518B:181168
  Output:
PassPackets :0                   PassBytes    :0
UnicastsPkts  :0                   MulticastsPkts:0
BroadcastsPkts:0

c300(config)#
下行数据已经到上行口：
c300(config)#show interface gei_1/19/4
gei_1/19/4 is up,  line protocol is up
  Description is none
  Keepalive set:10 sec
  The port negotiation is enable
  The port is optical
  Duplex full
  scramble payload-enable
  VLAN mode is trunk, pvid 1       BW 1000000 Kbits
  Last clearing of "show interface" counters never
120 seconds input rate :          101620 Bps,          1016 pps
120 seconds output rate:                6 Bps,             0 pps
  Interface peak rate  :
input          12678529 Bps, output                79 Bps
  Interface utilization: input    0.08130%,    output    0.00000%
  Input:
Packets       : 815438865             Bytes       : 647384976856

Unicasts       : 815438865             Multicasts    : 0

Broadcasts    : 0                      Undersize    : 0

Oversize       : 0                      CRC-ERROR    : 0

Dropped       : 0                      Fragments    : 0

Jabber          : 0                      MacRxErr    : 0

IncorrectVlanDrop: 0
  Output:
Packets       : 3689                   Bytes       : 251312

Unicasts       : 0                      Multicasts    : 18

Broadcasts    : 3671                   Collision    : 0

LateCollision : 0                      SingleCollision: 0

MultCollision : 0                      Dropped       : 0

  Input detail:
64B             : 0                      65-127B       : 35211489

128-255B       : 71478324                256-511B    : 142950319

512-1023B       : 285909069             1024-2047B    : 279889664


c300(config)#

问题就很奇怪了，有mac转发表，上行报文到了PON口，却无法转发到上行口，同样，下行报文到了上行口，却无法转发到PON侧？

通信人家园 (https://www.txrjy.com/)