|
1.各种机架的满配置功耗: JA00 1180W JB00 1092W JF00 1597W JF01 1513W JH00 2158W JH01 1910W JJ00 1844W JJ01 1546W JK00 800W JZ00 A(or B)-Branch有12个63A(X48V)熔丝,故从保险起见应一个熔丝对应二个 JA00,JB00,JF00,JF01,JJ00,JJ01,JK00机架,而JH00,JH01必须一个熔丝对应 一个,所以一个JZ00对应可供12至17个J架. 17个J架: JF00 JK00 JF01 JB00 JB00 JJ00 JJ01 JJ01 JJ01 JJ01 JH00/JH01(7个) 共12个熔丝 注:JF00和JB00不能共用一个熔丝(防止告警) 2.对机架发热提出的温度要求: 交换系统的各种设备应能在下列环境条件下正常工作,温湿度指在地板上方2米和主设备 前方0.4米处测量的数据. 温度 | 湿度% | 说明 15-25 | 30-70 |正常工作范围 10-30 | 25-80 |边缘工作范围,仅允许20%的使用期中出现 3.电源设备控制盘至电源架及电池的最大压降: 至MSC电源分配架,最大2.7V 至电池,最大0.7V 至整流器 4.接地: 为了考虑要扩容,故最好接地电阻等于或小于1欧姆. 术语： AS : ACCESS SWITCH ASYI: ASYNCHRONOUSINTERFACE BER : BATTERYEXTENSION RACK CAE : CUSTOMER APPLICATIONENGINEERING CL :CURRENT LOOP CLTD: CLOCK AND TONEDISTRIBUTION CPM : COMPUTER PERIPHERALMODULE TM : CLOCK AND TONE MODULE F : DISTRIBUTING FRAME RSU : EVOLUATED REMOTESUBSCRIBER UNIT GS : GROUP SWITCH GSS : GROUP SWITCH SECTION ICON: INDOOR CONCENTRATOR IF : INTERFACE KN : KILO NEWTON MPA : MASTER PANEL FORALARMS MDF : MAIN DISTRIBUTIONFRAME MMC : MAN MACHINECONTROLLER MPP : MODULAR POWER PLANT MPR : MODULAR POWER PLANTRACK MTF : MAGNETIC TAPEFORMATTER MTU : MAGNETIC TAPE UNIT MTUC: MAGNETIC TAPE UNITCONTROLLER PCU : PERSONAL COMPUTERUNIT PRA : POWER DISTRIBUTIONRACK PRI : PRINTER RCLK: RACK CLOCK SSA : SMALL STAND ALONE ST : STAGE STE : SUITE TERI: TERMINAL INTERFACE TSU : TERMINAL SELECTIONUNIT VDU : VISUAL DISPLAY UNIT S12的标准尺寸： AVERAGE WEIGHT OF RACKS 3000N RACK (TYPE "J") 900 X 520 MM SUITE END PANEL(TYPE "J") 50 X 520 MM VDU WORKSTATION 1524 X 762 MM PRINTER WORKSTATION 1143 X 762 MM GANGWAYS 680，980，1280MM MAIN GANGWAY MIN. 1300 MM SECONDARY GANGWAY MIN. 750 MM TOTAL RACK HEIGHT (SHIELDED) 2200 MM REQUIRED HEIGHT BETWEEN RAISED FLOOR AND LOWEST CEILING POINT (UNDER THE BEAMS) MIN. 2500 MM REQUIRED HEIGHT BETWEEN FLOOR AND LOWEST CEILING POINT (UNDER THE BEAMS) IN CASE OF TOP CABLING MIN. 3000 MM RAISED FLOOR 600 X 600 MM FLOOR PRESSURE MIN. 500 KILOGRAM/M2 THE HEIGTH OF THE RAISED FLOOR MIN. 300 MM HLR SIZE （A8330） 2200(h)X 900(w)X 650(d)MM HLR POWER CONSUMPTION (A8330) 1000W 标准机架类型： JA00-A1 ------- 8 * V02M (VARIABLE MODULE 2) 12 * V03M (VARIABLE MODULE 3) ------------------------------ 5 * TSU AND 10* AS JB00-A1 ------- 6 * V01M (VARIABLE MODULE 1) 8 * V03M (VARIABLE MODULE 3) 10 * V04M (VARIABLE MODULE 4) 4 * GS1/2 (GROUP SWITCH STAGE 1 AND 2) --------------------------------------- 5 * TSU AND 10* AS JF00-A1 ------- 4 * V01M (VARIABLE MODULE 1) 6 * V02M (VARIABLE MODULE 2) 2 * V03M (VARIABLE MODULE 3) 9 * ACE (AUXILIARY CONTROL ELEMENT) 1 * PTCE (PERMANENT TEST CONTROL ELEMENT) 2 * DEF (DEFENSE CONTROL ELEMENT) 2 * CTM (CLOCK AND TONE MODULE) 2 * CPM (COMPUTER PERIPHERAL MODULE) 1 * TTM (TRUNK TEST MODULE) 4 * GS1/2 (GROUPSWITCH STAGE 1 AND 2) 2 * MAGNETIC DISK 2 * OPTICAL DISK --------------------------------------- 3 * TSU AND 6* AS JF01-A1 ------- 16 * V01M (VARIABLE MODULE 1) 8 * V02M (VARIABLE MODULE 2) 2 * V03M (VARIABLE MODULE 3) 4 * CPM (COMPUTER PERIPHERAL MODULE) 1 * TTM (TRUNK TEST MODULE) 2 * MAGNETIC DISK 2 * OPTICAL DISK --------------------------------------- 3 * TSU AND 6* AS JH00-A1 ------- 80 * V01M (VARIABLE MODULE 1) 18 * V02M (VARIABLE MODULE 2) --------------------------------------- 16 * TSU AND 32* AS JH01-A1 ------- 20 * V01M (VARIABLE MODULE 1) 48 * V02M (VARIABLE MODULE 2) --------------------------------------- 11 * TSU AND 22* AS JJ00-A1 ------- 54 * V01M (VARIABLE MODULE 1) 18 * V02M (VARIABLE MODULE 2) 4 * GS1/2 (GROUPSWITCH STAGE 1 AND 2) --------------------------------------- 11 * TSU AND 22* AS JJ01-A1 ------- 54 * V01M (VARIABLE MODULE 1) 18 * V02M (VARIABLE MODULE 2) 8 * GS3 (GROUP SWITCH STAGE 3) --------------------------------------- 8 * TSU AND 16* AS JK00-A1 ------- 2 * MTD (MAGNETIC TAPE DEVICES) 2 * FORMATTERS 2 * TERMINATOPRS JZ00-A1 ------- 24 FUSES 6 CIRCUITBREAKERS MAX. 6A 4 CIRCUITBREAKERS MAX. 25A
| 
发表于 2012-11-11 20:00:10